Loading ...
Loading ...
Loading ...
Tighten blades to blade brackets by
using blade screws and washers.
NOTE: Before installing blade
brackets to the motor, please
remove the plastic inserts.
Remove the motor screws and washers
from the fan motor assembly.
Secure blade brackets to the motor with
washers and motor screws.
PAGE: 7 / 10
Fig.11
Blade Screw
Washer
Blade Bracket
Blade
Fan Light Installation:
Hex Nut
Washer
Switch Box
Cover
Plug
Fan Light
Threaded Pipe
Fig.14
Remove the plug from the switch box cover. Remove the nut and lock washer
from fan light. Attach the fan light to the switch box cover by threading the fan
light wires (black and white) and remove the threaded pipe through the hole of
switch box cover and then secure them onto the switch box cover with nut and
lock washer. Be sure it is tight enough to prevent light kit from vibrating loose.
Note: The glass shades of light kit and fan switch chain should be
staggered to avoid the fan switch chain and glass shades from getting
stuck or scratched.
Assembly without fan light
Make sure the lead wire of fan light
in switch box is sealed with a wire
connector exactly. Secure the switch
box cover into switch box with the
switch box cover screws.
Note: To install the fan light, skip this
step and proceed to Fig.14.
Remove the switch box cover screws
from the switch box cover first.
Switch Box
Screw
Fig.13
Slide the canopy up to ceiling and over
the two canopy screws on hanger
bracket. Rotate canopy counterclockwise,
next, while holding the canopy with one
hand, slide the canopy cover over the
screws and rotate counterclockwise until tight.
Note:Adjust the canopy screws as
necessary until the canopy and
canopy cover are snug.
Switch Box
Switch Box
Cover
Fig.12
Motor Screw
Blade Bracket
Plastic Insert
Washer
Fig.10
Canopy Screw
Canopy Screw
Key Hole
Slot
Hanger Bracket
Canopy
Canopy Cover
230208
Loading ...
Loading ...
Loading ...