Loading ...
Loading ...
Loading ...
10
Figure 10
11.9.2 Stationary guides
The stationary blade guides come pre-adjusted
from the factory. If adjustment is needed, follow the
below steps.
Refer to Figure 11.
1. Disconnect machine from power source.
2. Adjust spring loaded blade guide (A, Figure
11) by loosening or tightening the guide
adjustment screw (B).
3. The blade guide should place a light pressure
on the blade.
4. Connect machine to the power source.
Figure 11
11.10 Blade tracking adjustment
Since tracking can only be adjusted while machine
is running, it is suggested that this adjustment be
accomplished by qualified personnel that are
familiar with this type of adjustment and the
dangers associated with it.
Blade tracking has been set at the factory and
should require no adjustment. If a tracking problem
occurs, adjust the machine as follows:
Tracking adjustment is done
with the wheel covers open to observe the
blade. Use extreme caution to prevent coming
into contact with the blade.
1. Raise saw arm to its highest position.
2. Locate tracking adjustment plate on the
backside of the idle wheel.
3. Loosen the three bolts (A, Figure 12) located
on the top of the tracking nuts.
4. Tracking adjustment is accomplished by either
loosening or tightening three adjusting nuts (B,
Figure 12).
5. Tracking is set properly when the back of the
blade lightly touches the wheel flange. Note:
over-tracking (allowing blade back to rub hard
against wheel flange) will damage the blade
wheels and blade.
6. Tighten locking bolts (A) once proper tracking
is completed.
Figure 12
12.0 Maintenance
12.1 Lubrication and gearbox
All ball bearings are permanently lubricated and
sealed. They require no further lubrication.
The gearbox lubricant should be changed after the
first 3 months of operation. Use Mobil SHC 634, or
equivalent. Change lubricant from then on every
year.
To check level of gear box lubricant, place arm in
down position and allow a few minutes to pass so
that oil drains down. Check level in sight glass on
side of gear casing. Correct level is the dot in the
middle of sight glass.
Loading ...
Loading ...
Loading ...