Loading ...
Loading ...
Loading ...
MAINTENANCE
WARNING: FOR YOUR OWN SAFETY, TURN SWITCH
"OFF" AND REMOVE PLUG FROM POWER SOURCE
OUTLET BEFORE MAINTAINING OR LUBRICATING
YOUR SAW.
Do not allow sawdust to accumulate inside the saw.
Frequently blow out any dust that may accumulate inside
the saw cabinet and the motor.
Frequently clean your cutting tools with Craftsman Gum
and Pitch Remover.
A coat of automobile-type wax applied to the table will
help to keep the surface clean and allow workpieces to slide
more freely.
If the power cord is worn or cut, or damaged in any way,
have it replaced immediately.
Make sure the teeth of the ANTIKICKBACK pawls are
always sharp. To sharpen:
1. Remove blade guard.
2.
3.
4.
Rotate pawl toward rear of spreader so that teeth are
above top of spreader.
Hold spreader with left hand and place pawl over corner
of workbench.
Using a small roun,
teeth.
file (Smooth Cut) sharpen the
LUBRICATION
The saw motor bearings have been packed at the factory
with proper lubricant and require no additional lubrication.
The following parts should be oiled occasionally with SAE
No. 20 or No. 30 engine oil.
1. Tilt screw threads and pivot nut. (First Clean with
Craftsman Gum & Pitch Remover.)
2. Elevation screwthreads and pivot nut. (First Clean with
Craftsman Gum & Pitch Remover.)
L
ELEVATION SCREW
/
/
/
/
ELEVATION SCREW
PIVOT NUT
/
3. Cradle bearing points.
4. Bearing points in guard assembly, miter gauge and rip
fence.
TILT SCREW TILT SCREW
PIVOT NUT
ITEM
RECOMMENDED ACCESSORIES
CAT. NO. ITE M CAT.NO.
Steel Legs ............................... 9-22235
Steel Stand .............................. 9-22214
Caster Sets .................... 9-22222 or 9-22221
Solid Table Extension ...................... 9-29957
*7 in. Molding Head Set ............... 9-3217 9-3218
*7 in. Molding Head ........................ 9-3214
Molding/Dado Insert for 7 in
Dia. Molding or dado Head .................. 9-29933
Work Light ............................... 9-2480
*Smaller Dia. Molding Heads cannot be used because they
do not provide adequate depth of cut.
Work Light ............................... 9-2481
7 in. Dia. Adjustable Dado Head . 9-3261, 9-3262 & 9-3263
7 in. Dia. Dado Head ....................... 9-3257
Sanding Wheel ............................ 9-2274
Miter-Gauge Stop Rods ...... "............... 9-29924
Miter-Gauge Hold-Down Clamp .............. 9-29928
Taper Jig . ................................ 9-3233
Universal Jig .............................. 9-3231
"Power Tool Know How Handbook:" Table Saw .. 9-2918
The above recommended accessoriesare current and were
available at the time this manual was printed.
27
Loading ...
Loading ...
Loading ...