Loading ...
Loading ...
Loading ...
6. Lay a piece of flat straight wood and a square on saw
table and rotate the SPREADER SUPPORT until the
bracket is aligned with square.
7. MAKE SURE END OF SUPPORT, BRACKET AND
ROD ARE EVEN . .. usingan 1/8 in. setscrewwrench,
TIGHTEN THE SET SCREWS ONLY.
ENDS OF SURPORT
AND BRACKET TO
BE EVEN WITH
END OF ROD
/
TIGHTEN
SETSCREW ONLY
IMPORTANT: The SPREADER must always be
PARALLEL to the sawblade and in the MIDDLE of the cut
(KERF) made by the sawblade.
NOTE: The spreader is thinner than the width of the KERF
by approximately six thicknessesof !3aper.
SPACE EQUAL TO APPROX.
3 THICKNESSES OF PAPER KERF WOOD
- [
'1 3
i
SPACE EQUAL 1"O APPROX
3 THICKNESSES OF PAPER
LOOKING DOWN ON SAW
e.
Make two folds in a small piece (6 x 6 in.) of ordinary
NEWSPAPER making three thicknesses. The folded
paper will be usedasa "spacing gauge".
9. Install the SPREADER CLAMP. Placespreader between
spreader clamp and bracket. Move forward until all
three are in line. TIGHTEN WINGSCREWS.
10. Lift up both ANTIKICKBACK PAWLS... insert one
of the setscrew wrenches or a pencil in the notches to
hold the pawls out of the way.
11. Lay a piece of straight flat wood againstthe sawblade.
Insert folded paper between spreader and strip of wood.
12. MAKE SURE THE HEX NUTS UNDERNEATH ARE
LOOSE.
13. Hold the spreader tightly against the wood and make
sure the wood is against the saw blade. TIGHTEN THE
HEX NUTS.
This will align the spreader in the middle of the cut
(KERF) made by sawblade.
14
Er__ lil _,\ il ANrIKICKSACK PIECEOF
/,J /!/,!!/ PAW,S S_AIGHTWOOD
1
J _ NNN _. HOLD SPREADER
Loading ...
Loading ...
Loading ...