Loading ...
Loading ...
Loading ...
ADJUSTING RIP SCALE INDICATOR
1. Turn ELEVATION handwheel clockwise until blade is
up ashigh asit will go.
IMPORTANT: BLADE must be SQUARE (90 ° ) to
TABLE, in order to ALIGN rip fence.
2. Position fence on right side of sawblade so that it
touches the sides of the teeth.., tighten lock knob.
3. Loosen screw holding the indicator.., adjust indicator
so that it points to "2"... tighten screw.
NOTE: If you cannot adjust indicator so that it points
to "2", loosen the screws holding the front guide bar
and move the guide bar.
INDICATOR
LOCK KNOB
INSTALLING BLADE GUARD
1. From among the loose parts, find the hardware as
shown.
SQUARENUT _::::_ w,,./ SPREADERSUPPORT
"_ _'L-'-'_ SIPREADER BRACKET
SOCKET HEAD _--_..,=.-'_L.--._% ._ / SPREADER CLAMP
SETSCREW "_'J_ - r /
7/8 IN. LONG_ Le.e.e.e.e.e.e.e.e__/"
"--.. .lr o w,NoSCREW
//
FLAT WASHER J"'"(_) " ''_'_
HEX NUT ---"'_ LOCI(WASHER
EXT. I/4 iN.
2. MAKE SURE THE BLADE IS ALL THE WAY UP
AND SQUARE WITH THE TABLE.
3. Position SPREADER SUPPORT on rod until it is even
with the end of the rod.
4. Assemble the 7/8 in. long setscrews, nuts, Iockwashers
and washers to the SPREADER SUPPORT BRACKET
and slip the nuts into the slot in the spreader support.
5. Finger tighten ONLY THE HEX NUTS.
SQUARE NUT
SPREADER "_+
BRACKET
sOCKET _ I
HE
SETSCREW J
, "-.B
FLAT (_WASHER @_
LOCKWASHER
HEX NUT ""-"_
I
I
I
13
Loading ...
Loading ...
Loading ...