Loading ...
Loading ...
Loading ...
39
Push Bar
Command LED
Motion Sensor
Switch
LEARN Button
LOCK Button
LIGHT Button
Motion Sensor
Operation
Motion Detecting Control Panel
SYNCHRONIZE THE DOOR CONTROL: To synchronize the door control to the garage door
opener, press the push bar until the garage door opener activates (it may take up to 3 presses).
Test the door control by pressing the push bar; each press of the push bar will activate the
garage door opener.
PUSH BAR: Press the push bar to open or close the door.
LEARN BUTTON: Use to program compatible remote controls, wireless keyless entries and
myQ
®
devices to the garage door opener.
MOTION SENSOR: Turns the garage door opener lights on when motion is detected. Lights
stay on for 4-1/2 minutes (factory setting), then turn off. Set the motion sensor switch ON or
OFF to control this feature.
LOCK: Prevents remote controls from working, while still allowing activation from the door
control and keyless entry. (Factory setting is OFF.)
Turn ON: Press and hold the LOCK button for 2 seconds. The command LED will ash as
long as the lock feature is on.
Turn OFF: Press and hold the LOCK button for 2 seconds. The command LED will stop
ashing and normal operation will resume.
LIGHT BUTTON: Turns the garage door opener lights on or off when pressed. Lights stay on
for 4-1/2 minutes (factory setting). The LIGHT button will not control the lights when the door
is in motion.
To change the amount of time the lights stay on:
Press and hold the LOCK button (approximately 10 seconds) until the garage door opener
lights ash. The time interval is indicated by the number of times the garage door opener
lights ash:
1 ash is 1-1/2 minutes
2 ashes is 2-1/2 minutes
3 ashes is 3-1/2 minutes
4 ashes is 4-1/2 minutes
To cycle through the time intervals repeat the step above. If the push bar LED is continuously
blinking, the LOCK feature needs to be turned off.
To turn the light feature ON (Factory default is On):
1. Close the garage door.
2. Start with the garage door opener lights “ON”.
3. Press and hold the LIGHT button (approximately 10 seconds) until the garage door
opener lights turn off, then on again.
To turn the light feature OFF:
1. Close the garage door.
2. Start with the garage door opener lights “OFF”.
3. Press and hold the LIGHT button (approximately 10 seconds) until the garage door
opener lights turn off, then on again.
Loading ...
Loading ...
Loading ...