Loading ...
Loading ...
Loading ...
Figure 1
Figure 3
Sprocket
Trolley
Connector
Retaining Slot
Figure 2
Master Link
Threaded Shaft
Threaded Shaft with Spring Trolley Nut
HARDWARE
Master Link
Assembly
STEP 4 Install the Belt
1. Pull the belt around the idler pulley and toward the trolley. The ribbed side must contact
the pulley.
2. Hook the trolley connector into the retaining slot on the trolley as shown (Figure 1).
3. With the trolley against the screwdriver, dispense the remainder of the belt along the
rail length toward the motor unit and around the sprocket (Figure 2). The sprocket teeth
must engage the belt.
4. Check to make sure the belt is not twisted. Connect the trolley threaded shaft with the
master link (Figure 3).
a. Push pins of master link bar through holes in end of belt and trolley threaded shaft.
b. Push master link cap over pins and past pin notches.
c. Slide the closed end of the clip-on spring over one of the pins. Push the open end
of the clip-on spring onto the other pin.
5. Remove the spring trolley nut from the threaded shaft.
6. Insert the trolley threaded shaft through the hole in the trolley.
12
Loading ...
Loading ...
Loading ...