Loading ...
Loading ...
Loading ...
34
Without a properly installed safety reversal system, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing garage door.
• Safety reversal system MUST be tested every month.
• After ANY adjustments are made, the safety reversal system
MUST be tested. Door MUST reverse on contact with 1-1/2”
(3.8 cm) high object (or 2x4 laid at) on the oor.
If the door stops but does not reverse:
1. Repeat Program the Travel (see Adjustment Step 1);
2. Repeat the Safety Reversal test.
If the test continues to fail, call a trained door systems technician.
Without a properly installed safety reversing sensor, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing garage door.
1 Open the door. Place an obstruction in the path of the door.
2 Press the remote control push button to close the door. The door will
not move more than an inch (2.5 cm).
Adjustments
3 - Test the Safety Reversal System
1
With the door fully open, place a 1-1/2 inch (3.8 cm) board (or a 2x4
laid at) on the oor, centered under the garage door.
2 Press the remote control push button to close the door. The door
MUST reverse when it makes contact with the board.
4 -
Test the Protector System®
The garage door opener will not close from a remote control if the LED in
either safety reversing sensor is o (alerting you to the fact that the sensor
is misaligned or obstructed).
If the garage door opener closes the door when the safety reversing
sensor is obstructed (and the sensors are no more than 6 inches [15 cm]
above the oor), call for a trained door systems technician.
WARNING
Loading ...
Loading ...
Loading ...