Loading ...
Loading ...
Loading ...
CORD REPLACEMENT
DISCONNECT THE SANDER FROM POWER SUPP.
LY WHILE REPLACING PARTS OR MAKING AD-
JUSTMENTS.
1 Ren_ove handle cover and screws as described
on Page 7. Note the locations of all wiring in the
handle and how each connection is made to the
cord. Connections and wiring position must be
identical when installing the new cord See
Figure 14.
2. Remove the switch from the handle and discon-
nect the cord leads from the switch. See Figure
15
3. Removethebendrelieffromoldcordandplaeeit
on the new one.
4 Push each lead of the new cord as far as possible
into the groper switch lead receptacles. Pug on
leads to check lead connections with lead reeep-
tacles
5. Arrange the wiring in the handle so that it will not
be pinched when handle cover and screws are
replaced. Position the switch in place See
Figure 14.
6. Place the bend relief and cord in their correct
locations, then replace handle cover and screws
? Tighten all screws securely,
SCREWS
1/32 IN. DIAMETER
NAIL OR PIN
Fig 15
GENERAL
Only the parts shown on parts list, page eleven, are
intended to be repaired or replaced by the customer.
All other parts represent an important part of the
double insulation system and should be serviced on-
ly by a qualified service technician.
Avoid using solvents when cleaning plastic parts
Most plastics are susceptible to various types of
commercial solvents and may be damaged by their
use. Use clean ctoths to remove dirt, carbon dust,
etc.
When electric tools are used on fiberglass boats,
sports cars. etc., it has been found that they are sub
ject to accelerated wear and possible premature
failure, as the fiberglass chips and grindings are
highly abrasive to bearings, brushes, commutator,
etc. Consequently it is not recommended that this
tool be used for extended work on any fiberglass
material During any use on fiberglass it is extremely
important that the tool is cleaned frequently by blow
ing with an air jet. ALWAYS WEAR SAFETY GOG-
GLES, SAFETY GLASSES WITH SIDE SHIELDS, OR
A DUST MASK DURING POWER TOOL OPERATION
OR WHEN BLOWING DUST.
EXTENSION CORDS
The use of any extension cord wgl cause some loss
of power To keep the loss to a minimum and to pre-
vent tool overheating, follow the recommended cord
sizes on the chart at right When tool is used ouP
doors, use only extension cords suitable for Outdoor
use and so marked Extension cords are available at
Sears Retail Stores.
LUBRICATION
All the bearings in this tool are lubricated with a sup
ficient amount of high grade lubricant for the life of
the unit under normal operating conditions,
therefore, no further lubrication is required.
Extension Cord Length Wire Size A,W.G.
25-50 Ft 16
50-100 Ft 14
Page 9
Loading ...
Loading ...
Loading ...