Loading ...
Loading ...
Loading ...
- 24 -
Oil leaking at
pump
Pump pulsates
Oil seals worn.
Have replaced by AWSC.
Loose drain plug.
Tighten.
worn drain plug, o-ring
Check and replace.
worn fill plug g-ring
Check and replace.
Pump overfilled
Check for correct amount.
Incorrect oil used.
Drain and fill with correct amount
and type of oil.
Vent plug is clogged.
Clean vent plug; blow air through it to
remove any blockage. If problem
persists, replace plug.
Nozzle obstructed.
See spray wand paragraph in the
maintenance section for the correct
procedure.
TO FIND ALOCAL AUTHORIZED SERVICE CENTER NEAT YOU FOR
REPAIRS AND SERVICE PART PURCHASES.
GAS
Use fresh high quality unleaded gas. Add stabilizer to fuel tank and
run engine for 5 minutes before storage.
OIL
Pump oil: refer to owners manual supplied with this unit.
Engine oil: refer to engine manual supplied with his unit.
Some units are equipped with a low oil sensor and adequate oil
must be added or the unit will not start.
WATER
Use only cold water.
Do not operate unit with clogged or missing water filter/screen.
Do not operate unit without adequate water supply to
pump.Adequate water supply is a minimum of20 psi and 5gpm..
PRESSURE
ADJUSTMENT
The pressure setting is preset at the factory to achieve optimum
cleaning. If you need to lower the pressure setting, refer to the
operation manual for proper procedure.
Loading ...
Loading ...
Loading ...