Vevor BS170D-SP Gas Pressure Washer, 4400 PSI 4.0 GPM, Gas Powered Pressure Washer

USER'S MANUAL - Page 23

For BS170D-SP. Also, The document are for others Vevor models: G250A

PDF File Manual, 32 pages, Read Online | Download pdf file

BS170D-SP photo
Loading ...
Loading ...
Loading ...
- 21 -
It is Recommended That you follow these steps to protect the internal seals of the
pressure washer when STORING THE UNIT FOR MORE THAN 30
DAYSAND/OR WHEN FREEZING TEMPERATURES ARE EXPECTED.
4. Obtain a funnel, six ounces of RV antifreeze, and approximately 36 inches of
garden hose With a male hose connector attached to one end.
Use only RV antifreeze. Any other antifreeze is corrosive and can
damage pump.
5. Disconnect spark plug wire.
6. Connect 36 inch length of hose to water inlet of pump.
7. Add RV antifreeze to hose as shown.
8. Pull engine starter rope slowly several times until antifreeze comes out of high
pressure hose connection of pump.
9. Remove short hose from water inlet of pump.
10. Reconnect spark plug wire.
TROUBLESHOOTING GUDIE
Problem
Cause
Correction
Engine will not
start (see engine
manual for
further.engine
troubleshooting)
No fuel
Add fuel.
Low oil
Add required amount of oil.
Pressure builds up after two pulls on
the recoll starter or after initial use.
Squeeze gun trigger to reliever
pressure.
Choke lever in the no choke position
Move choke to the choke position.
Spark plug wire not at
Attach spark plug wire.
Engine ON/OFF switch in OFF position
Place engine ON/OF switch in on
position.
Choke lever in the choke
position on a hot engine or an
engine that has bean exposed to
thermal heat for a long pericd of time.
Move choke to the NO CHOKE
position.
Fuel valve closed.
Move fuel valve lever to the open
position
Loading ...
Loading ...
Loading ...