Loading ...
Loading ...
Loading ...
- 20 -
6.Reassemble the nozzle to the spray wand.
7.Reconnect spray wand to gun and turn on water supply.
8.Start pressure washer and place wand into high pressure setting to test.
HOW TO CLEAN THE WATER INLET FILTER
This screen filter should be checked periodically and cleaned if necessary.
1.Remove filter by grasping end and removing it from water inlet of pump as
shown.
2.Clean filter by flushing it with water on both sides.
3.Re-insert filter into water inlet of pump.note:cone side faces out.
NOTE: Do not operate pressure washer without filter properly installed.
STORAGE
ENGINE
Consult the owners manual of the manufacturers recommendations for storage.
PUMP
1. Drain all water from high Pressure hose,coil it, and store it in cradle of the
pressure washer handle.
2. Drain all water from spray gun and spray wand by holding spray gun in a vertical
position with nozzle end pointing down and squeezing trigger. Store in gun/hose
holder.
3. Store chemical hose, high pressure hose, spray lance so they are protected
from damage, such as being run over.
Loading ...
Loading ...
Loading ...