Loading ...
Loading ...
Loading ...
15
NOTE:
• If the wireless connection fails again, check
if there is conict or strong interference
(for example, interference from an electronic
device) around your location. Remove these
conicts or strong interferences and repeat
the above procedures.
• The subwoofer should be within 6m (18 feet)
of the soundbar in an open area.
• If the main unit is not connected with the
subwoofer and it is in On mode, the POWER
Indicator will ash. Follow step 1 ~ 4 above
to pair the subwoofer to the main unit.
5.8 Pair up with the Rear Speakers
Note
• Surround should be installed within a 6m range of
the main soundbar.
• When manually pair up soundbar with surround L,
the surround R must be powered off. When manually
pair up soundbar with surround R, the surround L
must be powered off.
• Do not press the Pair button on the rear of the
surround except for manual pairing.
Automatic Pairing
To the mains socket
1 Insert the Dongle of wireless rear surround
speaker.
2 Connect the power cord to both soundbar &
surround & connect both to a power source.
3 Turn on the soundbar. Both soundbar &
surround R/L will connect automatically
wirelessly.
Manual pairing
• If no audio from the surround can be heard,
manually pair up the surround.
1. Ensure that all the cables are well connected
and the soundbar is in Standby mode.
2. Press and hold the Pair button on the rear of
the surround for a few seconds. The surround
will enter the pairing mode and the Pair
Indicator will blink quickly.
3 Turn on the soundbar. Both soundbar &
surround R/L will connect automatically
wirelessly.
• The Pair indicator on the surround will
become solid when successful.
4. If the Pair indicator blinks, the wireless
connection has failed. Unplug the cable of
the surround and then reconnect the main
cable after 4 minutes. Repeat step 1 ~ 3.
6. Connect to Wi-Fi
6.1 WPS mode
If your router has Wi-Fi Protected Setup (WPS),
you can set up the connection without entering a
password.
1. Press and hold the PF (Wi-Fi Setup) button
for 4 seconds. You will hear a tone and the
Wi-Fi light will begin double blink.
2. Press the WPS button on your router. The
button is normally marked with this WPS logo.
WPS
3. Follow the instructions in the DTS Play-Fi app
to start pairing.
Loading ...
Loading ...
Loading ...