Loading ...
Loading ...
Loading ...
17
Regularly clean your grill between uses and especially after extended periods of storage.
Ensure that the grill and its components are sufciently cool before cleaning.
• Never handle hot parts with unprotected hands.
• In order to extend and maintain the life and condition of your grill, we strongly recommend
that the unit be covered when left outside for any length of time, especially during the
winter months.
Burner maintenance:
In most circumstances, burning off the residue after cooking will keep the burner clean. The burner should
be removed and cleaned annually or whenever heavy build-up is found in order to ensure that there is
no blockage (debris, insects) in either the burner portholes or venture tubes. Use pipe cleaner to clear
obstructions. A wire brush can be used to remove corrosion from the burner surfaces. When retting the
burner, be careful to check that the venture tubes of the burner t over the valve outlets.
Fittings and Storage:
Annual checking and tightening of metal ttings is recommended. Store the grill in a cool dry place. Cover
the burners with aluminum foil in order to prevent insects or other debris from collecting in the burner holes.
If the grill is to be stored indoors, the gas bottle must be disconnected and left outside. The gas bottle should
always be stored outside, out of reach of children, and in a dry, well-ventilated area away from any sources
of heat or ignition.
PROBLEM POSSIBLE CAUSE SOLUTION
Burner will not light using the
ignition system.
1. Check battery.
2. LP gas cylinder is empty.
3. Faulty regulator.
4. Obstructions in the burner.
5. Obstructions in gas jets or
gas hose.
6. Electrode wire is loose or
disconnected on electrode or
ignition unit.
7. Electrode or wire is
damaged/faulty push button
igniter.
8. Needle is either too close or
too far from burner.
1. Replace with a good battery.
2. Replace with full cylinder.
3. Have the regulator checked or
replaced.
4. Clean burner.
5. Clean jets and gas hose.
6. Reconnect wire.
7. Change electrode and wire
change igniter.
8. Needle should be 1/8 of an
inch to 1/4 of an inch from
burner tube.
Burner will not light with a match. 1. LG gas cylinder is empty.
2. Faulty Regulator.
3. Obstructions in burner.
4. Obstructions in gas jets or
gas hose.
1. Replace with full cylinder.
2. Have the regulator checked
or replaced.
3. Clean Burner.
4. Clean jets and gas hose.
Fire in burner tube has a low
ame or ashback (a hissing or
roaring noise may be heard)
1. LP gas cylinder is empty.
2. Obstructions in burner.
3. Obstructions in gas jets or gas
hose.
4. Windy conditions.
1. Use larger cylinder.
2. Clean burner.
3. Clean jets and gas hose.
4. Use grill in a more sheltered
position.
CARE AND MAINTENANCE
TROUBLE SHOOTING
Loading ...
Loading ...
Loading ...