Loading ...
Loading ...
Loading ...
– 16 – – 17 –
EN
EN
11 . Maintenance and Storage
Important: Read all the safety information listed in this
manual before attempting to maintain, service or repair
this product.
WARNING! ALWAYS ensure that the fan is
switched o, disconnected from mains power
and that the blades have completely stopped
before working on this product.
CAUTION! Remove parts from the fan where
possible before cleaning them to avoid
moisture accessing the motor. Dry parts
thoroughly before reassembly.
• Clean the grilles using a damp cloth ONLY.
• Clean the blade assembly and other plastic parts
using a damp cloth and soapy water ONLY.
• NEVER use solvents or aggressive chemicals for
cleaning as these may damage plastic or insulated
parts of the fan.
• Clean the fan thoroughly before storage.
• When storing the fan, cover it in a plastic bag to
protect it from dust and store it in a clean and dry
location out of reach of children.
• Remove any batteries from the remote control if
it will be stored or unused for extended periods.
10. The Remote Control
Important: Some functions are only accessible via the
remote control. Keep it safe.
10.1 Remote Control Overview
(29) Remote o button
(30) Remote on/speed button
(31) Remote oscillation button
(32) Timer button
(33) Mode button
(34) Battery compartment cover
The o (29), on/speed (30) and oscillation (31) buttons
behave in the same way as the corresponding buttons
(18) (19) (20) on the fan control panel.
10.2 Replacing the Batteries
The remote control requires two AAA batteries to
operate. To install or replace the batteries:
1. Slide the battery compartment cover downwards
and away from the remote.
2. Remove any installed batteries and insert two AAA
batteries, observing the correct polarity.
3. Slide the battery compartment cover back into place
until it locks.
Important: ALWAYS dispose of used batteries
responsibly and in accordance with local regulations.
10.3 Mode Selection
The fan is equipped with three airow modes; see 9.4
Fan Modes. The mode must be selected using the
remote control.
The fan retains the mode that was active at the time it
was switched o and starts up in this mode. To select the
next available mode, press the mode button (33).
10.4 Setting the Timer
The fan is equipped with a shutdown timer; see 9.5
Shutdown Timer. The timer must be congured using
the remote control and can be set in 30-minute
increments. The maximum timer period is 450 minutes
(7.5 hours).
The timer must be reset every time the fan is switched on
if it is needed. The fan does NOT remember the timer
congured during the previous operation.
To enable the timer:
1. Press the timer button (32) on the remote control;
this illuminates the 30-minute timer indicator (25)
on the control panel.
2. Press the timer button again to increase the timer
period; the indicators illuminate as appropriate to
show the congured period.
3. To cancel the timer, press the timer button
repeatedly until all timer indicators are o or switch
the fan o.
Important: The timer period cannot be reduced. If a
shorter timer period is required, cancel the timer and
press the timer button until the correct period is
congured.
Fig. 14
Loading ...
Loading ...