Loading ...
Loading ...
Loading ...
2.
Figure 12
Set the adjustment lever (refer to Figure 9) in
the first or second notch at the top for beveling.
See Figure 12.
Figure 13
3. Set the adjustment lever (refer to Figure 9) in
the fourth or fifth notch at the bottom for
trenching. See Figure 13.
SECTION 7: ADJUSTMENTS
WARNING: Do not at any time make
any adjustment to lawn mower without
first stopping the engine and disconnect-
ing spark plug wire.
Briggs & Stratton
Engines
NOTE: Your engine may be a constant speed
engine and not equipped with a throttle control.
THROTTLE CONTROL ADJUSTMENT
If the throttle control needs adjustment or if it has
been replaced, adjust as follows.
1. Remove the screw shown in Figure 14. Remove
the cable clamp from the cable.
NOTE: If you have a Tecumseh engine, simply
loosen the screw shown in Figure 15 so the cable
will move freely beneath the clamp. It is not
necessary to remove the screw and clamp
completely.
2. Push the throttle control lever on the handle all
the way forward as far as it wilt go, then back it
off one "click." Make certain the throttle control
lever remains in this position.
3. Push the control lever on the engine as far
toward the rear of the engine as it will go.
Secure the cable in this position with the cable
clamp and screw.
Control
Lever
On Engine
Figure 14
Tecumseh Engines
Cable
Clamp
Figure 15
Control
Lever
On Engine
Screw
Loading ...
Loading ...
Loading ...