Loading ...
Loading ...
Loading ...
SECTION 11: TROUBLE SHOOTING GUIDE
Trouble
Enginefails to start
Engine runs erratic
Possible Cause(s)
Dirty aircleaner.
Choke not in ON position.
Fuel tank empty, or stale fuel.
Throttle control lever not in
starting position.
Spark plug wire disconnected.
Faulty spark plug.
Engine flooded.
Unit running on CHOKE.
Spark plug wire loose.
Stale fuel.
Vent in gas cap plugged.
Water or dirt in fuel system.
Dirty air cleaner.
Carburetor out of adjustment.
Engine oil level low.
Air flow restricted.
Corrective Action
Refer to the engine manual packed with your unit.
Move switch to ON position.
Fill tank with clean, flesh gasoline. Fuel will not last over
thirty days unless a fuel stabilizer is used.
Move throttle lever to FAST position.
Connect wire to spark plug.
Clean, adjust gap or replace.
Refer to the engine manual packed with your unit.
Move choke to OFF position.
Connect and tighten spark plug wire.
Fill tank with clean, flesh gasoline. Fuel will not last over
thirty days unless a fuel stabilizer is used.
Clear vent.
Drain fuel tank. Refill with flesh fuel.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Fill crankcase with proper oil.
Stop engine and disconnect spark plug wire. Refer to the
engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Refer to the engine manual packed with your unit.
Engine overheats
Dirty aircleaner.
Carburetor not adjusted
properly.
Excessive vibration at Spindle bent. Replace spindle.
blade Ball bearings worn out. Replace ball bearings.
Belt slips Belt worn or stretched Adjust clutch rod or replace belt.
The edger head will not Lack of lubrication. Lubricate compression spring on spindle housing assembly
go down to the last with oil.
position
Note: For repairs beyond the minor adjustments above, contact your local authorized service dealer.
13
Loading ...
Loading ...
Loading ...