Loading ...
Loading ...
Loading ...
Figure7
PRIMER
The primer is used to pump gas into the carburetor.
Use it to start a cold engine, but do not use it to
restart a warm engine after short shutdown. Refer to
the engine manual.
Figure 8
Figure 9
BLADE TILT CONTROL
The cutting blade can be adjusted to five positions;
from beveling to edging to trenching. To adjust,
make sure the engine is not running. Release the
adjustment lever on the pivot bracket and pivot the
lever to the desired cutting position. Place the
adjustment lever in the notch desired. See Figure 9.
NOTE: Become familiar with all the controls and
adjustments before operating the edger so you can
adjust it easily to a variety of edging conditions. DO
NOT ATTEMPT TO MAKE ANY ADJUSTMENTS
while the engine is running.
Loading ...
Loading ...
Loading ...