Loading ...
Loading ...
Loading ...
Configuring DHCP Service Configuration Examples
User Guide 583
5.1.4 Using the CLI
1) Enable DHCP Server.
Switch#configure
Switch(config)#service dhcp server
2) Specify the Pool Name, Network Address, Subnet Mask and Lease Time.
Switch(config)#ip dhcp server pool pool
Switch(dhcp-config)#network 192.168.0.0 255.255.255.0
Switch(dhcp-config)#lease 120
Switch(dhcp-config)#exit
3) Bind the specified IP address to the MAC address of the FTP server.
Switch(config)# ip dhcp server pool pool
Switch(dhcp-config)# address 192.168.0.8 hardware-address FC-AA-14-59-E9-4A
hardware-type ethernet
Switch(dhcp-config)#end
Switch#copy running-config startup-config
Verify the Configuration
Switch#show ip dhcp server binding
IP Address Client id/Hardware Address Type Lease Time Left
---------- -------------------------- --------- ---------------
192.168.0.2 01-d43d-7ebf-615f Automatic 01:57:27
192.168.0.8 01-fcaa-1459-e94a Manual Infinite
5.2 Example for DHCP Interface Relay
5.2.1 Network Requirements
The administrator deploys one DHCP server on the network, and wants the server to assign
IP addresses to the computers in the Marketing department and the R&D department. It
is required that computers in the same department should be on the same subnet, while
computers in different departments should be on different subnets.
After adding the DHCP server, the network topology will be as shown in Figure 5-5.
The Marketing department and the R&D department belong to VLAN 10 and VLAN 20,
respectively. The IP address of VLAN interface 10 is 192.168.2.1/24, and the IP address of
VLAN interface 20 is 192.168.3.1/24. The DHCP server is connected to the routed port of
Loading ...
Loading ...
Loading ...