Loading ...
Loading ...
Loading ...
9
1 2 4
5
10
3
1
2
6 7 98
11 12
GENERAL ASSEMBLY INSTRUCTIONS
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
2. Undo the latches (Fig. 2).
3. Lift the powerhead o the collection tank (Fig. 3).
4. Remove the contents from inside the collection tank. Make sure you have all contents as listed on
page 8 (Fig. 4).
5. Turn the collection tank upside down and insert the four casters into the sockets on the bottom of
the base. Press casters down until they snap into place (Fig. 5).
6. Insert the handle into the slots located on the top of the powerhead (Fig. 6). Apply pressure until
the handle snaps into place.
7. Your vacuum comes ready for dry vacuum cleaning. If the reusable cloth lter is not installed, refer
to page 15 for installation instructions (Fig. 7).
8. For wet vacuum cleaning, remove the reusable cloth lter, and install the supplied foam wet lter.
See page 16 for the foam wet lter installation instructions (Fig. 8).
9. Place the powerhead back on the collection tank aligning the top section with the latches, and
snap into place (Fig. 9 & 10).
10. Insert the larger end of the hose into the vacuum port on the collection tank (Fig. 11).
11.
Choose the desired accessory and insert onto the free end of the hose or extension wand (Fig. 12).
UNPACKING YOUR WET/DRY VACUUM & GENERAL ASSEMBLY
WARNING:
DO NOT PLUG THE POWER CORD INTO A
POWER OUTLET. MAKE SURE THE PLUG IS DISCONNECTED BEFORE
ASSEMBLING THE WET/DRY VACUUM. TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT EXPOSE TO RAIN.
Loading ...
Loading ...
Loading ...