Loading ...
Loading ...
Loading ...
35
Interrupting the wash cycle
9 CAUTION
Expansion (overpressure) may cause the appliance
door to open and/or water to escape! If the door
was opened on an appliance which has a hot water
connection or is heated, always leave the door ajar
for several minutes and then close.
1.
Open the door.
2.
Switch off On/Off switch (.
The LED’s go out. The wash cycle is saved.
3.
To continue the wash cycle, switch on the On/Off
switch ( again.
4.
Close the door.
Note: Your dishwasher is protected against unintentional
operation. If the appliance door remains open for more
than 4 seconds after pressing the Start button, the
operation will be paused. Press the Start button again
and close the appliance door.
Cancel a cycle (reset)
1.
Open the door and press and hold the Start button
)* for approximately 3 seconds until the digital
display @ shows: "Program was terminated".
2.
Close the door.
3.
Wait about 1 minute while the dishwasher drains.
4.
Open the door and press the On/Off switch (.
Changing the wash cycle
When the Start button ( has been pressed, the wash
cycle cannot be changed. The only way a wash cycle can
be changed is by terminating the wash cycle (Reset).
Loading ...
Loading ...
Loading ...