Loading ...
Loading ...
Loading ...
18 19
10. Remove and discard the paper filter used during the
cleaning cycle. If a MR. COFFEE
®
permanent filter was
used during cleaning, remove it and rinse it thoroughly
before replacing it in the filter basket.
11. Begin brewing and allow the full brew cycle to complete.
12. Repeat Steps 8 through 11 one more time.
Your coffeemaker is now clean and ready to brew the next
pot of delicious, hot coffee!
Suggested Decalcifying Interval:
Type of Water Cleaning Frequency
Soft Water Every 80 Brew Cycles
Hard Water Every 40 Brew Cycles
or when red light is flashing
Water Filtration Disk Replacement:
Your water filtration disk will need to be replaced once a
month (approx. 30 brew cycles). If the machine will not be in
use for an extended period of time, rinse the water filter with
running water and clean the coffeemaker before use.
Cleaning the Decanter:
Hard water can leave a whitish stain on the decanter, and
coffee may then turn this stain brown.
To remove decanter stains:
1. Fill the decanter with a solution of equal parts water and
vinegar and let the solution stand in the decanter for
approximately 20 minutes.
2. Discard the solution, then wash and rinse the decanter.
Do not use harsh abrasive cleaners that may scratch the
decanter, scratches may cause the decanter to break.
USING THE CLEAN FUNCTION TO DECALCIFY
YOUR COFFEEMAKER (JPX MODEL ONLY)
The Clean Indicator will illuminate when it is recommended
to clean and decalcify your coffeemaker using vinegar. To
decalcify your coffeemaker, follow the steps below.
1. IMPORTANT: Remove the Advanced Water Filtration
System from the coffeemaker.
2. Prepare 4 cups or 20 fl. oz. of undiluted, white
household vinegar. Pour the vinegar into the water
reservoir on the carafe side.
3. Place an empty 8-12 cup basket-style paper filter or a
Mr. Coffee Reusable Coffee Filter into the brew basket.
4. Place the empty carafe on the unit, centered on the
warming plate.
5. Press the BREW/STOP button down
and hold for 3 seconds so that the
BREWING indicator is lit. The prepared
cleaning solution will begin being
brewed through the coffeemaker.
(Figure 10)
6. The entire cycle will take
approximately 45 minutes to
complete. The Clean Indicator will
turn off when the cycle is complete.
7. Discard the cleaning solution and rinse the carafe
thoroughly with clean water.
8. Fill the water reservoir with 12 cups of clean, fresh
water.
9. Place the empty carafe back on the coffeemaker,
centered on the warming plate.
10. Remove and discard the paper filter used during the
cleaning cycle. If a Mr. Coffee Reusable Coffee Filter was
used during cleaning, remove it and rinse it thoroughly
before replacing it in the brew basket.
Figure 10
BVMC-EHX Series_BVMC-JPX Series_23ESM1.indd 18-19BVMC-EHX Series_BVMC-JPX Series_23ESM1.indd 18-19 2023/6/21 08:242023/6/21 08:24
Loading ...
Loading ...
Loading ...