Loading ...
Loading ...
Loading ...
How to use remote control
Press the Smart button
to run in smart purify
mode.
Smart
Signaling window
Send signals to host of
air purifier.
adjust In manual mode,
purify mode and purify
speed manually.
Manual
Timer button
Set the timer function
the Set shutdown time when
-1h-machine is on
4h-8h
Set startup time when the
machine stands by -1h-
4h-8h
and shutdown (Timer startup
is unavailable at the same
time)
In smart purify, mute and
button is sleep mode, this
in disenabled. However,
manual mode, the speed
Low - Middle - is cycled in
High - Turbo order.
Purify speed
Press anion button to
enable anion function. Press
this button again to
disenable anion function.
Anion
Sleep
Press the sleep button to
run in sleep mode.
ON/OFF button
to turn the Press this button
air purifier on, and press it
again to stop.
In standby mode, press this
to start up and run in button
last operating state.
Tips
the first time, please When you use this remote for
from button battery.remove the isolation plastic paper
If of CR2025.The battery used on this remote control is
six continuously forthe remote control has been used
months, or if the remote control does not work properly,
in time.please replace the battery
replacing the battery, pay attention to correct When
installation direction of positive and negative electrodes,
as shown in the figure below on the left.
Disposal of battery: please remove the battery when not
in use for a long time. When the battery is used up,
discard the battery in a recycling unit.
Placement of remote control: the remote control contains
magnets and can be closely attached to back of the
machine, as shown in the figure on the right.
Mute
Press the mute button to run
in mute mode.
Loading ...
Loading ...
Loading ...