Loading ...
Loading ...
Loading ...
4, Pivot seat and panforward and assemble
adjustment knob and flat washer loosely.
Do not tighten.
Fiat Washer
Adj Knob
5. Lower seat into operating position and
sit in seat.
6. Slide seat until a comfortable position is
reached which allows you to press clutch/
brake pedal al! the way down,
7, Get off seat without moving its adjusted
position.
8, Raise seat and tighten adjustment knob
securely,
CHECK BATTERY
Make sure battery is securely fastened,
and that all wires are securely connected.
• Battery is located under the seat.
• Battery has been fully charged from the
factory, before installation,
Battery
NOTE; Battery should only be charged using
charger specified in "BATTERY" section in
the service and adjustments section of this
manual. Charger can be purchased at your
local service center.
NOTE: You may now roll your riding
mower off the skid. Follow the appropriate
instruction below to remove the riding mower
from the skid.
WARNING; Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Be sure
riding mower is in a well-ventilated area.
Be sure the area in front of riding mower is
clear of other people and objects.
TO ROLL RIDING MOWER OFF
SKID (See Operation section for
location and function of controls)
I. Raise deck lift lever to its highest
position,
2, Release parking brake by depressing
clutch/brake pedal.
3. Engage freewheel control. See "TO
TRANSPORT" in the operation section
of this manual,
4, Roll riding mower fontcard off ski&
CHECK TIRE PRESSURE
The tires on your riding mower were
overinflated at the factory for shipping pur-
poses. Correct tire pressure is important
for best cutting performance.
• Reduce tire pressure to PSI shown on
tires,
CHECK DECK LEVELNESS
For best cutting results, mower housing
should be properly leveled. See "TO LEVEL
MOWER HOUSING" in the Service and
Adjustments section of this manual,
CHECK FOR PROPER POSITON OF
MOWER DRIVE BELT
See the figure that is shown for replacing
the mower drive belt in the service and
adjustment section of this manual° Verify
that the belt is routed correctly,
CHECK BRAKE SYSTEM
After you learn how to operate your rid_
ing mower, check to see that the brake
is operating properly, See "TO ADJUST
BRAKE" in the Service and Adjustments
section of this manual.
8
Loading ...
Loading ...
Loading ...