Loading ...
Loading ...
Loading ...
Page 13
ASSEMBLY
FIG. 4a
A
D
C
E
B
WARNING: To avoid injury, do not connect this
drill press to a power source until it is completely assembled
and adjusted and you have read and understood the
operator’s manual.
(ITEMS NOT SUPPLIED)
Star-head screwdriver
13mm Open-end wrench or adjustment wrench
Hammer or rubber mallet
Framing square
Ruler
(ITEMS SUPPLIED)
4mm Hex key (1 pc)
Chuck key
Block of wood
UNPACKING YOUR DRILL PRESS
YOU WILL NEED
Do not use this product if any parts of the package contents are already assembled to your product when you unpack it.
Package contents are not assembled to the product by the manufacturer and require customer installation. Use
of a product that may have been improperly assembled could result in serious personal injury.
• Carefully remove all parts from the shipping carton.
• Carefully lift tool from the carton and place it on a level work surface.
• Inspect the tool carefully to make sure that no breakage or damage occurred during shipping.
• Do not discard the packing material until you have carefully inspected and satisfactorily operated the tool.
• Remove the protective oil that is applied to table, base and column. Use any ordinary household grease and spot remover.
• Apply a coat of paste wax to the table, column and machined surfaces of base to prevent rust. Wipe all parts thoroughly
with a clean, dry cloth.
• If any parts are damaged or missing, please call 1-877-684-8912 for assistance.
WARNING: The use of attachments or accessories not listed in this manual might be hazardous and could cause
serious personal injury.
WARNING: Do not attempt to modify this tool or create accessories not recommended for use with this tool. Any
such alteration or modication is misuse, and could result in a hazardous condition leading to possible serious personal
injury.
WARNING: Do not connect to the power supply until assembly is complete. Failure to comply could result in
accidental starting and possible serious personal injury.
BASE TO COLUMN (Fig. 2)
• Set the base (A) on the oor.
• Place the column/support assembly (B) on the base (A),
align the column support holes with the base holes.
• Install a hex bolt M8 x 25 (C), a at washer 8 (D) and a
Loading ...
Loading ...
Loading ...