Loading ...
Loading ...
Loading ...
Installation Procedure
Note:
Left + right filler panel assembly
Top Rail and Side Panels at each side are offset to provide the proper pitch
to the rear of (5/16”). This is necessary for proper condensed water utilization and
drainage. If you are not using the Side Panels for any reason, this pitch to the rear
must be maintained!
Step 1:
Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels -
be sure to use the proper panel for each side. When installed, the flange for
securing the panel in place to the window sill will be facing into the room.
A. Hold the side Panel in one hand and gently pull back the center to free the open
end. See FIG. 1.
B. Slide the free end “T” section of the panel directly into the cabinet as shown in
FIG. 2. Slide the panel down. Be sure to leave enough space to slip the top and
bottom of the frame into the rails on the cabinet.
C. Once the panel has been installed on the side of the cabinet, make sure it sits
securely inside the frame channel by making slight adjustments. Slide the top and
bottom ends of the frame into the top and bottom rails of the cabinet. See FIG. 3.
D. Slide the panel all the way in and repeat on the other side.
FIG. 2FIG. 1
FIG. 3
Top Rail
Bottom Rail
“T” section
9
How to install:
Choose a location where there are
no
any obstacle surrounding the unit,
and the plug is accessible.
cording to the following diagram.
Over
1500 mm
500mm 500mm
300mm
300mm
Location
7KHGLVWDQFHEHWZHHQWKHDLUFRQGLWLRQHU
DQGWKHDURXQGREVWDFOHVVKRXOGPHHW
WKHUHTXLUHPHQWDVEHORZRYHUPP
XSSHUVLGHRYHUPPOHIWVLGH
RYHUPPULJKWVLGHRYHUPP
IURQWVLGHDQGRYHUPPUHDUVLGH
Loading ...
Loading ...
Loading ...