Loading ...
Loading ...
Loading ...
Installation
Instructions
Page 19
MWMW050CM1A Model MWMWT060CR1A Model
B2: For Vinyl-Clad windows:
Fig. 8B
Fig. 8C
Drive 1/2” (12.7 mm)
locking screws through
the top rail and into
the window sash
(Fig.8B/8C).
NOTE: Before driving
the screws, drill 5 holes
into the window through
the holes of the top rail
and side panel frames as
shown (Fig.8B/8C).
Fig. 9
Fig. 10
FOAM SEAL
C. Secure lower sash in place
by attaching the sash lock
with the 3/4” (19 mm) or
1/2” (12.7 mm) screw as
shown (Fig. 9).
D. Cut Window sash seal
foam and insert it in the
space between the upper
and lower sashes (Fig.10).
If AC is Blocked by Storm Window
Storm window
frame or other
obstruction.
SASH
1-1/2"min
(38 mm)
Board thickness
as required, for
proper pitch to
rear, along entire
sill. Fasten with
nails or screws.
Fig. 11
Add wood as shown in Fig. 11, or remove
storm window before air conditioner is
installed.
If storm window frame must remain,
be sure the drain holes or slots are not
caulked or painted shut. Accumulated
rain water or condensation must be
allowed to drain out.
Removing AC From Window
• Turn AC o, and disconnect power cord.
• Remove sash seal from between windows, and unscrew sash lock.
• Remove screws installed through top rail and side panel frames.
• Close (slide) the side panels into the rails.
• Keeping a firm grip on the air conditioner, raise the sash and carefully remove.
• Be careful not to spill any condensate while lifting unit form window. Store parts
WITH air conditioner.
Loading ...
Loading ...
Loading ...