Loading ...
Loading ...
Loading ...
Installation Instructions
B INSTALLING THE WATER LINE (CONT.)
I_ CONNECT THE TUBING
TO THE REFRIGERATOR
NOTES:
• Before making the connection to the refrigerator,
be sure the refligerator power cord is not plugged
into the wall outlet.
• _re recommend installing a wamr filter ifyour wamr
supply has sand or particles that could clog the
screen of the refligerator's water vane. Install it in
the water line near the refligeratoL If using GE
SmartGonnect'" Refiigeramr Tubing kit, you will
need an additional robe (X_X08X10002) to connect
the filmL Do not cut plastic tube to install filmL
Remove the access coveL .-_r-----_ [
Remove the plastic flexible
cap fiom the water valve
(refiigerator connection).
O
Place the compression nut and ferrule (sleeve)
onto the end of the tubing as shown. On (7;E
SmartGonnect '_'Refligerator Tubing kit,
the nuts are aheady assembled to the tubing.
Insert the end of the tubing into the water valve
connec6on as far as possible. While holding the
tubing, tighten the fitting.
For plas6c robing flom a GE SmartGonnect'"
Refrigerator Tubing kit, insert the molded end
of the tubing into the shutoff valve and tighten
compression nut un61 it is hand 6ght, then
dgbten one additional ulrn with a wrench.
Overdghtening mW cause leaks.
Fasten the ulbing into the clamp provided
to hold it in a vertical position. You may need
to pry open the clamp.
1/4"Copper
Tubing TubingClamp
1/4"Compression
Nut
Ferrule(sleeve)
RefrigeratorConnection
SmartConnect_
Tubing
Reatmch the access co__ A..Co- o q; ll
I-8--1TURN THE WATER
ON AT THE
SHUTOFF VALVE
Tighten any connections
that leak.
PLUG IN THE REFRIGERATOR
Arrange the coil of tubing so that it does not vibrate
against the back of the refligerator or against the
wall. Push the refligerator back to the wall.
I_ISTART THE ICEMAKER
On power switch models, set the icemaker power
switch to the / (0n) position. On feeler arm models,
move the feeler arm to the ON (down) position. The
icemaker will not begin to operate until it reaches
its operating temperature of 15°F (-9°(0 or below.
It will then begin operation automatically.
Powerswitchmodel
in
theON(down)position
Feelerarmmodel
NOTE: In lower water pressure conditions, the
water valve may tuin on up to 3 times to deliver
enough water to the icemakeL
12
Loading ...
Loading ...
Loading ...