Loading ...
Loading ...
Loading ...
17
4. Remove the lower-left cable gland and install the
bottom entry power conduit plug (K) to the charger.
Bottom Entry
Loosen the left cable gland and insert the AC input
cable into the inlet hole.
Step 2
1. Strip the wires to 1/2" (12 mm).
2. Connect the wires (L1, L2, and Ground) as per the
diagram and tighten each connector screw to
17.7 in·lbs (2 N·m).
3. For bottom entry: Reinstall the left strain relief
by inserting and tightening the two screws. Then
tighten the left cable gland.
4. Reconnect the cables which was unplugged when
removing the middle cover.
5. If the connection to the Ethernet cable and/or
RS485 cables (see Section 3.6 and 3.7) are not
needed, reinstall the faceplate and middle cover
and tighten the screws.
Loading ...
Loading ...
Loading ...