Loading ...
Loading ...
Loading ...
14
Placement
1. Find the wall stud nearest to and on the right side of
the power supply wiring using a wall stud finder.
Alternatively, you may find a suitable location on a
solid wall.
2. Draw a vertical line of approximately 20" (50 cm) in
line with the wall stud at the approximate height of
your mounting.
3. P
lace the wall dock with the center holes aligned with
the vertical line. Mark the two lower mounting holes
(A) and remove the wall dock.
4. For rear entry wiring, mark the cable exit where the
AC input cable will come out from the wall. Ensure
that the cable exit matches the wall dock notch as per
the diagram.
Mounting the Wall Dock
1. Drill two 5/16" holes and insert two 5/16" diameter
wall anchors into the lower mounting holes.
2. Attach the wall dock to the mounting location by
inserting two M6 x 50 screws (B) into the lower
mounting holes. Tighten the screws using the PH2
screwdriver (not included in the package).
Mounting the Charger
Refer to Step 4 and Step 5 on page 13 to mount the charger.
Loading ...
Loading ...
Loading ...