Loading ...
Loading ...
Loading ...
17
EN
Before using for the rst time
General information
• Only use pure water without
carbonation.
• Use the supplied test strip to determine
the hardness of the water used and set
the water hardness ("Water hardness
and lter" page 18).
Information for using for the rst
time
The appliance must be vented before
it is used for the rst time. To do so,
the appliance may only be switched on
without a Melitta
®
Claris
®
water lter and
with a completely lled water reservoir.
• Place a vessel under outlet 2.
• Press the button to switch on the
appliance. illuminates on the display.
• Press the button. Water will be
pumped through the system.
• The appliance is ready for operation
when illuminates on display 9.
• After using the appliance for the rst
time, insert the Melitta
®
Claris
®
water
lter if required (see page 19).
Starting up the appliance
Starting up
Warning!
Danger of re and electric shock
due to incorrect supply voltage,
incorrect or damaged connections
and power cable.
– Ensure that the supply voltage
corresponds to the supply voltage
specied on the identication label of
the appliance. The identication label is
located on the right side of the appliance
behind the cover (Image A, 11).
– Make sure that the power socket meets
the applicable standards for electrical
safety. If in doubt, contact a qualied
electrician.
– Never use damaged power cables
(damaged insulation, bare wires).
• Place the appliance on a stable, dry and
level surface with sufcient clearance (at
least 10 cm) to the sides.
• Plug the power cable into a suitable
power socket.
• Remove the lid from the bean
container 7.
• Fill the bean container with suitable
coffee beans.
• Put the lid back on.
• Raise the lid of the water reservoir 6 and
pull the water reservoir up and out of the
appliance.
• Fill the water reservoir with fresh tap
water only up to the max. mark.
BA_Solo_082016.indd 17 21.09.2016 07:23:52
Loading ...
Loading ...
Loading ...