Loading ...
Loading ...
Loading ...
29
Guidelines for ventilation
This appliance may only be set up in a sufficiently ventilated
room and according to the applicable regulations and
ventilation requirements.
Please note that the air volume required for combustion must
not be below 2 m³/h per kW of power (see kW total power on
the rating plate).
Installation
This appliance is always supplied with a set of adjustable feet
and, depending on the model, with a splash guard. The
appliance may also be used without the splash guard.
Fitting the adjustable feet
1. Remove all parts that are not permanently fixed, especially
the pan supports and burners.
2. Remove the accessories from the oven.
3. Tilt the appliance by lifting one side from the floor.
4. Screw the adjustable feet and the plates into the mounting
holes on the underside of the appliance. If you then want to
move the appliance, fully screw in the adjustable feet.
5. Only finally level the appliance when the electricity and gas
have been connected and all of the installation work has
been completed.
Fitting the splash guard
1. Remove the packaging and the protective film from the
splash guard.
2. Screw the splash guard onto the rear of the appliance using
the 2 screws, each with a washer, retaining washer and nut.
Electrical connection
Only a licensed expert may connect the appliance. The
appliance must be installed according to the most recent IEE
regulations (Institute of Electrical Engineers). The appliance
may be damaged if incorrectly connected.
Make sure the voltage of the power supply corresponds to the
specified value on the rating plate. The rating plate can be
found on the inside of the storage compartment flap.
Ensure that the power supply is properly earthed and that the
fuse and the wiring and piping system in the building can
withstand the load from the appliance.
It is recommended that you configure the circuit for the
appliance to 16 A.
When you route the cable, make sure that:
■ the cable is not trapped or squashed.
■ the cable, for example, does not come into contact with
sharp edges or cutting edges.
■ the cable does not come into contact with parts that can
reach temperatures of more than 50°C above room
temperature.
Connecting the mains cable
Where the appliance is directly connected to the power supply,
an all-pole isolating switch with a contact gap is required.
Complete disconnection in compliance with the conditions
specified in overvoltage category III must be guaranteed.
The earth cable is excluded from this.
Replacing the mains cable
The mains cable is replaced via the terminal block. The terminal
block is located on the back of the appliance.
The mains cable must be of the following type:
■ H05RRF
■ 3 x 0.75 mm²
■ 230 V~
Leave the mains cable slightly overlong so that you can pull out
the appliance for cleaning purposes.
Proceed as follows:
1. Open the terminal box.
2. Loosen the screw (A) on the terminal block.
Loading ...
Loading ...
Loading ...