Loading ...
Loading ...
Loading ...
7
⚫ IMPORTANT: You must observe the ventilation
requirements shown in the drawing opposite.
⚫ IMPORTANT: There are ventilation holes around the
outside of the hob. YOU MUST ensure that these
holes are not blocked by the work top, when you put
the hob into position (see drawing opposite).
⚫ IMPORTANT: Do not use a silicon sealant to seal the
appliance against the aperture. This will make it
difficult to remove the hob from the aperture in future,
particularly if it needs to be serviced.
⚫ Carefully turn the hob back over and then gently lower it into the aperture hole that
you have cut out.
Fitting guidelines
The ceramic hob is manufactured to work with two-phase
alternating current (400V2N~50Hz).The voltage rating of the
ceramic hob heating elements is 230V. Adapting the ceramic
hob to operate with one-phase current is possible by
appropriate bridging in the connection box according to the
connection diagram below. The connection diagram is also
found on the cover of the connection box. Remember that
the connection wire should match the connection type and
the power rating of the ceramic hob.
The connection cable must be secured in a strain-relief clamp.
Warning!
Remember to connect the safety circuit to the connection box terminal marked with
.The electricity supply for the ceramic hob must have a safety switch which
enables the power to be cut off in case of emergency. The distance between the
working contacts of the safety switch must be at least 3mm.
Before connecting the ceramic hob to the power supply it is important to read the
information on the data plate and the connection diagram.
wires for each domino hob with 4D models
model
Adaptive voltage range and wires
The wiring diagram
220-240 1N～
380-420 2N～ 50-
KADO K 1/5
2
1
Loading ...
Loading ...
Loading ...