Loading ...
Loading ...
Loading ...
25TROUBLESHOOTING
Oven
PROBLEM POSSIBLE CAUSE
Oven or grill
not working
• Time of day not set.
• Power not turned on.
• Controls are incorrectly set.
• Oven is in ‘Demo’ mode, refer to Using your oven section.
• Household fuse has blown or power supply is off.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
• Child-proof oven lock is activated. ‘LOCKED’ is displayed when control is
touched. (Refer to Using your oven section)
The oven seal is loose • The oven seal is only attached at each corner. It may seem like a loose fit but
when the oven door is closed it will function correctly.
Oven light
not working
• Light may be turned off at control panel.
• Lamp blown or loose in socket.
• Household fuse has blown.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
Oven not heating enough • Foil or trays on bottom of oven.
• Timer is in “AUTO” mode. (Refer to timer operating instructions)
• Household fuse has blown.
NOTE: If the household fuse continues to blow, call the Customer Care Centre.
• Oven not pre-heated. Pre-heat oven for 30 minutes.
Clock flashing
on display
• Reset time of day and any cooking functions you were using.
Unit smoking
when first used
• Protective oils being removed.
Condensation
build up
• Reduce the amount of water used in cooking. (Sometimes condensation is
normal)
Door cannot be replaced
after removal
• Stirrup not engaged properly.
Functions and temperature
appear on display but oven
does not work
• Oven is in ‘Demo’ mode, refer to Using your oven section.
When the door is open the fan
stops (underbench only)
• This is a function of the power board to help reduce the blast of air when
opening the door.
When a non fan mode is
selected the fan starts
• Most oven modes have a fast heat up function that uses the fan, fan element
and top (boost) elements. Auto fast heat up can be overridden by selecting a
temperature of 120°C or less, allowing the function to start, then increasing the
temperature to the desired level.
The light stays on when the
door is closed
• An oven function has been selected.
• The light has been turned on at the control panel.
The light does not turn *ON*
when the door is opened
• Oven light may need replacing.
Shelf slides out when door is
opened
• Oven cavity is not level, you can perform a check using a level to verify this
(refer to installation section). If not level refer to installer.
There is warm air coming from
the top of the oven door
• The oven is located under the control panel. When the oven is on, the air passes
through this vent. This venting is necessary for proper air circulation in the oven
and good baking results. Do not block oven vent.
NOTE: Only authorised personnel should carry out servicing.
TROUBLESHOOTING
Loading ...
Loading ...
Loading ...