Loading ...
Loading ...
Loading ...
INTERIOR MOISTURE WARNING
IMPORTANT: For optimum performance, Waterproof Fire Safes should be opened and aired
out for at least 30 minutes every two weeks to prevent any build up of moisture inside. It is
recommended to occasionally do this for longer periods. This will balance the humidity difference
inside and outside and allow any excess moisture trapped inside to escape. If you do not open
Waterproof Fire Safes on a regular basis to let them air out, you may begin to notice a musty
smell, especially on paperwork. The manufacturer will not be responsible for any damage or loss of
items placed in Waterproof Fire Safes due to moisture. Proper care and preventative maintenance
of Waterproof Fire Safes is the owner’s responsibility. The owner should understand that this is
required to assure continued levels of protection and trouble-free performance during the lifetime.
2
The batteries must be installed before using your safe. The battery compartment is located inside
the safe on the lock cover panel.
1. Remove battery compartment cover and insert 4 “AA” batteries. Make sure that the
batteries are installed in the correct direction with regard to polarity (+ and -).
(Figure 1 & Figure 2).
2. Proper installation of the batteries will cause the keypad to beep once, the red and green LED
lights will flash twice and the keypad back light will flash once.
3. Replace the battery cover (Figure 3).
4. Leave the door open. Proceed to the “Testing Digital Lock” section on next page.
INSTALL BATTERIES
GETTING STARTED
1. Remove override access rubber lock cover (Figure 1).
2. Insert the override access key into the lock until it stops (Figure 2).
3. With the key inserted turn clockwise to the right (Figure 3).
4. Turn the door handle upwards counterclockwise and pull the safe door open
(Figure 4 & Figure 5).
IMPORTANT: IF THE HANDLE WILL NOT TURN UPWARDS COUNTERCLOCKWISE, FIRST
TURN THE HANDLE SLIGHTLY BACK TO THE LEFT UNTIL IT STOPS, THEN TURN UPWARDS
COUNTERCLOCKWISE AGAIN TO OPEN.
5. Remove override access key and store it in a safe place away from the safe. Replace the
cover over the key lock, leave safe door open, and proceed to “Install Batteries”.
Figure 1 Figure 2 Figure 3 Figure 4 Figure 5
1
2
3
4
5
6
8
9
0
#
*
7
1
2
3
4
5
6
8
9
0
#
*
7
1
2
3
4
5
6
8
9
0
#
*
7
Figure 1 Figure 2 Figure 3
Loading ...
Loading ...
Loading ...