Loading ...
Loading ...
Loading ...
Safety instructions for assembly
WARNING: Read, understand and obey
these instructions carefully before you use
the product.
• Remove the battery from the product before you
assemble the product.
• Use approved protective gloves.
• When you use a saw blade or a grass blade, make
sure that the correct handlebar, the blade guard and
the harness are attached to the product.
• A defective or incorrect guard can cause injury. Do
not use a cutting attachment that does not have an
approved guard attached.
• Make sure that you assemble the cover and shaft
correct before you start the product.
• The drive disc and support flange must engage
correctly in the centre hole of the cutting attachment.
A cutting attachment that is attached incorrectly can
cause injury or death.
• To operate the product safely and prevent injury to
the operator or other persons, the product must
always be attached correctly to the harness.
Safety instructions for maintenance
WARNING: Read the warning instructions
that follow before you do maintenance on
the product.
• Remove the battery before you do maintenance,
other checks or assemble the product.
• The operator must only do the maintenance and
servicing shown in this operator's manual. Turn to
your servicing dealer for maintenance and servicing
of a larger extension.
• Do not clean the battery or the battery charger with
water. Strong detergent can cause damage to the
plastic.
• If you do not do maintenance, it decreases the life
cycle of the product and increases the risk of
accidents.
• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Keep the teeth of the blade correctly sharpened.
Obey our recommendations. Also refer to the
instructions on the blade package.
• Only use original spare parts.
• Always use heavy duty gloves when you repair the
cutting attachment. The blades are very sharp and
can easily cause injuries.
Assembly
To attach the handle
1. Remove the nut and screw from the bottom of the
handle.
2. Attach the handle onto the handlebar.
3. Align the screw hole in the handle with the screw
hole in the handlebar.
4. Put the screw into the screw hole at the bottom of
the handle and through the handlebar.
5. Attach the nut on the screw and tighten the nut.
To assemble the handlebar
1. Put the handlebar into the bracket.
2. Attach the knob but do not tighten fully.
609 - 002 - 27.06.2019 11
Loading ...
Loading ...
Loading ...