Loading ...
Loading ...
Loading ...
They will stop appearing after the vehicle protocol is detected and a
confirmation message of “XXX Protocol” is displayed.
• If a “LINK ERROR!” message shows up, turn the ignition off for
about 10 seconds, check if the Scan Tool’s OBDII connector is
securely connected to the vehicle’s DLC, and then turn the ignition
back to on. Repeat the procedure from step 5. If the “LINK ERROR”
message does not go away, then there may be problems for the
Scan Tool to communicate with the vehicle.
6. Wait for the main menu to come up after a brief overview
displaying the scanning results with the total number of DTCs and
the overall I/M Monitor Status.
7. Select “DTC” from the main menu by pressing the ENTER button.
• If there are no Diagnostic Trouble Codes retrieved, the display will
indicate “NO CODES”.
• If there are any Diagnostic Trouble Codes, then the total number of
the
Fault Codes followed by that of the Pending Codes will be reported on
the display.
DTC: 02
IM: YES
MENU:
1. DTC
NO
CODES
12
Loading ...
Loading ...
Loading ...