Loading ...
Loading ...
Loading ...
Drawer Removal
Drawers will stop before
coming all the way out of the
refrigerator to help prevent
contents from spilling onto
the floor Drawers can easily
be removed by tilting up
slightly and pulling past
"stop" location
On some models you may
need to remove the door
bins from the fresh food door
before removing the drawers
When replacing the drawers
make sure you stide them
through the drawer guides
on the left side
If the door prevents you from taking out the drawers, the
refrigerator will need to be rolled forward until the door
opens enough to sfide the drawers out In some cases
when you roll the refrigerator out you will need to move
the refrigerator to the left as you roll it out
Drain Opening in Freezer Compartment
When cleaning, remove the
freezer bin and flusha
solution of baking soda (one
teaspoon [5 mill and two
cups (500 ml) of hot (not
boiling) water through the
drain line with the help of a
meat baster This will help eliminate odor and reduce the
likelihood of a clogged drain line. If drain becomes
clogged, use a meat baster and baking-soda-and-water
solution to force the clog through the drain line
Under Refrigerator
The condenser is located
behind the base grille For
most efficient operation,
remove the base grille (see
page 3} and sweep away or
vacuum up dust that is readily
accessible For best results, Clean the condenser
use a brush specially coils at least once a year
designed for this purpose
It is available at your Sears store or service center Thiseasy
cleaning operation should be done at least once a year
Behind Refrigerator
Take care moving your refrigerator away from the wall
All types of floor coverings can be damaged, particularly
cushioned coverings and those with embossed surfaces_
Pu!l the refrigerator straight out and return it to position by
pushing it straight in Moving refrigerator in a side
direction may damage floor covering or refrigerator,,
When pushing the refrigerator back, make sure you don't
roll over the power cord or icemaker supply fine,
Light Bulb Replacement
Unplug refrigerator before changing a light bulb_
Fresh Food Compartment-Upper Light
1. Pull off temperature control knobs
2o Pull the bottom Pin
of the light shield
down and forward,
then rotate the top
up and off
After replacing with
same size bulb,
reinstafl light shield,
Fresh Food Compartment--Lower Light (on somemodels)
This light is located behind the top drawer or right above
the top drawer (depending on your model),
1. Unplug the refrigerator-
2. If the light is behind the top drawer you will need to
remove the drawer and the shelf above it, To remove the
drawer see the Drawer Removal section in Care and
Cleaning
• To remove the shelf first
remove any food on the shelf,
Then tilt lhe shelf up at the
front and lift it up and out
of the tracks,
3, Grasp the bottom of the
light shield and pull it
forward and up
4. After replacing wilh the same size bulb, replace the shield
If you cannot locate the correct bulb, see your dealer,
5. tf the light was behind the top drawer, you will need to
replace the drawer and the shelf above it,
• To replace the sheff, raise the shelf front slightly and
place the top hooks in the lowest large track slots. Then
lower the front of the shelf until it is level
6. Plug the refrigerator back in
Freezer Compartment
1. Remove shelf just below light
panel. (Shelf will be easier to
remove if it isemptied first )
2o Pull plastic light panel
toward you (it will bend to free tabs from grooves.)
3. After replacing with same size bulb, reinstall panel
and shelf,
13
Loading ...
Loading ...
Loading ...