Loading ...
Loading ...
Loading ...
56V LITHIUM-ION CORDLESS SNOW BLOWER — SNT2120AP/SNT2120AP-FC34
TROUBLESHOOTING
WARNING: Always remove the battery pack(s) when servicing or transporting
the snow blower. Always protect your hands by wearing gloves when performing any
maintenance on the snow blower auger or scraper.
PROBLEM CAUSE SOLUTION
Side rails don't stay
in position.
◾
Lock knobs on the side rails
and/or quick-release levers are
not secured.
◾
Make sure that lock knobs on
the side rails are fully tightened
and the quick-release levers are
fully closed.
Snow blower is not
starting.
◾
Battery charge is low.
◾
Charge the battery.
◾
The auger is frozen by snow
or ice.
◾
Remove the battery pack(s) rst,
then use a clean-out tool to clear
the snow or ice that obstruct the
auger. Reinstall the battery packs
and restart the snow blower.
◾
The battery pack is overheated.
The LED indicator on the battery
pack(s) ashes orange or shines
red (see the section “BATTERY
HIGH-TEMPERATURE
PROTECTION” in this manual.)
◾
Remove the overheated battery
pack(s) from the snow blower
and wait until the battery pack(s)
cools down to approximately
152°F (67°C). Reinstall the
battery pack(s) and restart the
snow blower.
◾
Incorrect steps made to power
on the snow blower.
◾
(1) Press the safety button until
the power indicator ashes
green. (2) With the button
depressed, pull the bail switch
upward to meet the main handle.
◾
Unidentied fault
◾
Contact EGO service center for
repair.
The motor is on but
the auger does not
turn.
◾
The drive belt is worn or
broken.
◾
Replace the drive belt following
the section “REPLACING THE
DRIVE BELT” in this manual.
Loading ...
Loading ...
Loading ...