Loading ...
Loading ...
Loading ...
English 89
If the number of hours of operation is exceeded, the
DESCALE NEEDED message will be displayed each time
when a new heating mode is selected. Select ENTER to
continue. After the Descaling operation is finished, the
operation hour counter will be reset and the message will
no longer be displayed.
You can start DESCALE only when the oven is set to OFF
and is completely cooled down. Once descaling begins, it
should not be interrupted. It is very important that all rinse
cycles are completed.
Descaling Phase (cycle 1)
1. Using only the descaling powder recommended for this
oven (BSH part number 573828; obtain from your
retailer or order from http://www.thermador-eshop.com),
mix 32 oz. (1 quart or 0.95 liter) of water with a packet of
powder descaler to produce the descaling solution.
2. Empty the water tank and refill it with the descaling
solution.
3. On the display, under the SETTINGS menu, scroll with
the “+/–” buttons to DESCALE and press “ENTER”.
— The display will then show START DESCALE?
YES”.
4. Press “ENTER” to begin descaling.
— The display will show EXPOSURE PHASE on the
first line and 10:00 on the second line, and the
countdown to 0:00 begins. At this point DESCALE
PHASE is displayed, and with a time of 20 minutes.
At the end of the descaling phase, the countdown is
suspended and a beep will sound. The display will show
CLEAN DISH, FILL TANK on the first line and AND WIPE
OUT OVEN on the second line.
First Rinse Cycle (cycle 2)
5. Remove the water tank and wash it out thoroughly, fill it
with water and slide it back in.
6. Using the cleaning sponge provided with your range (or
a comparable soft cloth or sponge), wipe any water out
of the evaporator dish and wipe out the oven.
Thoroughly wash out the cleaning sponge.
7. Press “ENTER” to start the first rinse cycle.
— The display will show 1ST RINSE on the first line.
The countdown will resume.
8. After 20 seconds, a beep will signal the end of the first
rinsing cycle.
— The display will show CLEAN DISH on the first line
and PRESS ENTER BUTTON on the second line.
9. Using the cleaning sponge, wipe any water out of the
evaporator dish.
Second Rinse Cycle (cycle 3)
10. Press “ENTER” to start the second rinse cycle.
— The display will show 2ND RINSE on the first line.
The countdown will resume again.
11. After 20 seconds, a beep will signal the end of
DESCALE.
— The display will show DESCALE FINISHED on the
first line and CLEAN DISH on the second line.
12. Using the cleaning sponge, wipe any water out of the
evaporator dish and wipe out the oven. Thoroughly
rinse out the cleaning sponge.
13. Using a soft cloth, dry the oven cavity.
Cleaning the Rack Rail Frames
The rack rail frames can be removed for cleaning.
Pull the rack rail frame toward you and remove. Use
dishwashing soap and a kitchen sponge or brush to clean
the rack rail frames. The rack rail frames can also be
washed in the dishwasher.
Installing the Rack Rail Frames
Hang the back and front parts of the frame and then push it
back until it locks into place.
Each rack rail frame only fits on one side.
Water Hardness Operation Hour Counter
1 – softened unlimited, no message
2 – soft 400 hours
3 – medium 200 hours
4 – hard 100 hours
5 – very hard
70 hours
Figure 44: Rack Rail Frames
11 11
22 22
Loading ...
Loading ...
Loading ...