Loading ...
Loading ...
Loading ...
-16-
Service
Preventive maintenance
performed by unauthorized
per so n nel may result in misplacing of
internal wires and components which
could cause serious hazard. We
recommend that all tool service be performed
by a Skil Factory Service Center or
Autho rized Skil Service Station.
TOOL LUBRICATION
Your Skil tool has been properly lubricated and
is ready to use. However it is recommended
that the gears be relubricated only with Skil
lubricants: No. 80111 (8 oz. tube).
Always check the oil level before using the saw.
To check and add oil: Remove plug from power
source and place the saw’s foot on a horizontal
surface with tool set to maximum depth of cut.
Remove oil plug using the same wrench used
to remove the saw blade. The oil level should
never be below bottom threads in the housing.
When adding oil, fill until oil starts to run out of
oil hole at arrow on housing and replace oil
plug (Fig. 15).
NOTE: If oil is dirty or thick, replace the oil plug
and run the saw for one minute to warm up the
oil. Then remove oil plug and turn saw upside
down, to remove all oil. Add fresh Skil lubricant.
With a new saw, change the oil after the first
ten hours of use.
CARBON BRUSHES
The brushes and commutator in your tool have
been engineered for many hours of
dependable service. To maintain peak
ef ficiency of the motor, we recommend every
two to six months the brushes be examined.
The brushes should be free from dust and dirt.
Brushes should be replaced when they have
worn down to 3/16" in length. The brushes
should slide freely in and out of the holders
without sticking.
To check brushes: Disconnect plug from
power source. Unscrew the brush caps on the
motor housing and lift out the brushes; note
which way they face, so that the brushes can
be returned to their original position. To
replace the blade side brush, remove the
brush cap with flat head screwdriver,
accessing through the hole in the upper guard.
Clean the brush holder openings with com -
pressed air or a clean cloth and replace the
brushes and caps.
Only genuine Skil replacement brushes
specially designed for your tool should be
used.
BEARINGS
Bearings which become noisy (due to heavy
load or very abrasive material cut ting) should
be replaced at once to avoid overheating or
motor failure.
Cleaning
The tool may be cleaned most effectively with
compressed dry air. Always wear safety
gog gles when cleaning tools and guarding
system with compressed air.
Ventilation openings and switch levers must
be kept clean and free of foreign matter. Do
not at tempt to clean by inserting pointed
objects through openings.
Certain cleaning agents
and sol vents damage
plastic parts. Some of these are: gasoline,
carbon tetrachlo ride, chlo rinated cleaning
solvents, ammonia and house hold detergents
that contain ammonia.
Maintenance
!
CAUTION
!
WARNING
To avoid accidents always dis connect the tool from the power supply
before cleaning or performing any main tenance.
!
WARNING
FIG. 15
OIL PLUG
OIL LEVEL
INSTRUCTIONS
2017-1016_SPT70V_16 inch SKILSAW Worm Drive_manual_SPT70V 2017/10/16 17:30 页 16
Loading ...
Loading ...
Loading ...