Loading ...
Loading ...
Loading ...
RIP CUTS
The combination blade provided with your saw
is for both cross cuts and rip cuts. Ripping is
cutting lengthwise with the grain of the wood.
SAWDUST EXTRACTION
To extract sawdust created during cutting,
connect a suitable extraction unit with suction
hose to the dust elbow.
Always wear a dust mask
during use.
-15-
CUTTING LARGE SHEETS
L
arge sheets and long boards sag or bend,
depending on support. If you attempt to cut
without leveling and properly supporting the
piece, the blade will tend to bind, causing KICK-
BACK and extra load on the motor (Fig. 13).
Support the panel or board close to the cut, as
shown in (Fig. 14). Be sure to set the depth of
the cut so that you cut through the sheet or
board only and not the table or work bench. The
two-by-fours used to raise and support the work
should be positioned so that the broadest sides
support the work and rest on the table or bench.
Do not support the work with the narrow sides
as this is an unsteady arrangement. If the sheet
or board to be cut is too large for a table or work
bench, use the supporting two-by-fours on the
floor and secure.
CORRECT
FIG. 13
INCORRECT
FIG. 14
!
WARNING
2017-1016_SPT70V_16 inch SKILSAW Worm Drive_manual_SPT70V 2017/10/16 17:30 ้กต 15
Loading ...
Loading ...
Loading ...