Loading ...
Loading ...
Loading ...
Installation Instructions
BOTTOM VENTING (cont.)
ADDING A NEW DUCT
Reconnect the cut
portion A of the
duct to the blower
housing.
Tape the elbow
in (] 90-degree
position to
prevent rotation.
Insert the elbow
through the rear hole
and connect it to
portion A. Rotate
the elbow through
the bottom opening.
Portion"A"
Fixinghole
Rearhole
Bottom
opening
While holding down
the pipe and elbow, using
your hand through the rear
opening, drill (] 1/8" hole
through the bottom tab
hole and the pipe (Is
shown in the illustration. Bottomview
NOTE: IVioke sure the hole is drilled oil the woy
through the elbow ond pipe.
-A CAUTION: Be sure not to pullor
demege the electricel wires inside the dryer
when inserting the duct.
While still holding down
the pipe and elbow from
the rear opening, screw
the pipes in place with
the previously saved screw.
Apply duct tape Duct tape
aS shown on the joint _% _<"
between the dryer internal
duct and the elbow.
NOTE: Make sure the tape
covers the screw hole in
portion A where it connects
to the elbow.
-A CAUTION: Internal duct joints must
be secured with tape; otherwise, they may
separate end cause e safety hazard.
Dryer Exhaust to the bottom of cabinet
for Gas and Electric models.
ADDING COVER PLATE TO REAR OF CABINET
(BOTTOM EXHAUST)
Connect standard metal elbows and ducts to
complete the exhaust system. Cover back opening
with (] plate (Kit WE1M454) (]vc]ilc]ble from your
local service provider. Place dryer in final locution.
-A WARNING -NEVERLEAVE
THE BACK OPENING WITHOUT THE PLATE.
(Kit WEIM454)
31
Loading ...
Loading ...
Loading ...