Loading ...
Loading ...
Loading ...
— 16 —
Proper maintenance of the Range Hood will ensure proper performance of the unit.
Use a warm detergent solution. Grease lters are dishwasher safe.
Stainless steel is one of the easiest materials to keep clean. Occasional care will help preserve its appearance.
Cleaning tips:
• Hot water with soap or detergent is all that is usually required.
• Follow all cleaning by rinsing with clear water. Wipe dry with a clean, soft cloth to avoid water marks.
• For discolorations or deposits that persist, use a non-scratching household cleanser or stainless steel polishing powder
with a little water and a soft cloth.
• For stubborn cases, use a plastic scouring pad or soft bristle brush with cleanser and water. Rub lightly in direction of
polishing lines or “grain” of the stainless nish. Avoid using too much pressure, which may mar the surface.
• DO NOT allow deposits to remain on surface for long periods of time.
• DO NOT use ordinary steel wool or steel brushes. Small bits of steel may adhere to the surface causing rust.
• DO NOT allow salt solutions, disinfectants, bleaches, or cleaning compounds to remain in contact with stainless steel
for extended periods. Many of these compounds contain chemicals which may be harmful. Rinse with water after
exposure and wipe dry with a clean cloth.
Painted surfaces should be cleaned with warm water and mild detergent only.
Maintenance
Hood Cleaning
u
Make sure the range hood is unplugged or turn OFF
breaker.
v
Open the wiring compartment with a Phillips
screwdriver, and unplug the light (Figure 11). Gently
use screwdriver to push down until light pops out
from its location. Pull out the LED light.
CAUTION: LIGHT MAY BE HOT, PLEASE TAKE
OUT THE LIGHT WHEN THE LIGHT IS
COMPLETELY COOL!
w
Replace with appropriate LED light. Please contact
Ancona customer service for replacement. Plug in
new light and push back into light panel.
x
Turn ON breaker and range hood to test for
operation.
Replacing the Light
IMPORTANT:
ALWAYS SWITCH OFF THE ELECTRICITY SUPPLY AT THE MAIN PANEL BEFORE CARRYING OUT ANY OPERATION
ON THE APPLIANCE.
Figure 11
Loading ...
Loading ...