Ancona AN-18056WHT Product Manual:

Loading ...

— 13 —

STEP 9

Electrical Connection

• Depending if using the wiring hole A or hole B, connect cable to range

hood wiring (see Figure 7).

• Connect BLACK to BLACK, WHITE to WHITE and GREEN to GREEN

(see Figure 8).

• DON’T FORGET TO CONNECT THE GROUND! (green wire)

SAFETY WARNING: Risk of electrical shock. This range hood

must be properly grounded. Make sure this is done by a qualiﬁed

electrician in accordance with all applicable national and local

electrical codes. Before connecting wires, switch power off at service

panel and lock service panel to prevent power from being switched on

accidentally.

Figure 7

Figure 8

IMPORTANT:

• Observeallgoverningcodesandordinances.

• It is the customer’s responsibility to contact a qualified electrical installer.

• Ifcodespermitandaseparategroundwireisused,itisrecommendedthata

qualified electrician determine that the ground path is adequate. A 120-Volt, 60

Hz,AC-only,fusedelectricalsupplyisrequiredonaseparate15-ampcircuit,

fused on both sides of the line.

• DONOTgroundtoagaspipe.

• Checkwithaqualifiedelectricianifyouarenotsurethattherangehoodisproperlygrounded.

• DONOThaveafuseintheneutralorgroundcircuit.

IMPORTANT: Save this Installation Guide for electrical inspector’s use.

GROUNDING INSTRUCTIONS:

• Thisappliancemustbegrounded.Intheeventofanelectricalshort-circuit,groundingreducestheriskofelectric

shock by providing an escape wire for the electric current.

WARNING: Improper grounding can result in a risk of electric shock.

• Consultaqualifiedelectricianifthegroundinginstructionsarenotcompletelyunderstood,orifdoubtexistsasto

whether the appliance is properly grounded. DO NOT use an extension cord. If the power supply cord is too short,

have a qualified electrician install an outlet near the appliance.

• Therangehoodmustbeconnectedwithcopperwire/plugonly.Therangehoodshouldbeconnecteddirectlyto

the fused disconnect (or circuit breaker) box through flexible armored or non-metallic sheathed copper cable. UL/

CSA listed strain relief must be provided at each end of the power supply cable. Use only with range hood cord-

connection kits that have been investigated and found acceptable for use with this model.

Installation

Loading ...

Ancona AN-18056WHT 30" 160 CFM Convertible Under Cabinet Range Hood in