Loading ...
Loading ...
Loading ...
7
TRUE
SPEC SERIES: STR, STA & STG
www.truemfg.com
STANDARD ACCESSORIES
PILASTER INSTALLATION & OPERATION
TRUE STR, STA, and STG cabinets are available with four different
shelving / tray slide options.
Type Kit #1. Angle Type Tray Slide
Type Kit #2. Rod Style Tray Slide
Type Kit #3. Universal Tray Slide
Type Kit #4. Shelf Standards (shelf clips)
REQUIRED TOOLS:
• Standard Screwdriver (Flathead)
• Rubber / Plastic Mallet
• Tape Measure
INSTALLATION PROCEDURES (WIRE SHELVES):
Wire shelves come with shelf clips (image 1).
Properly insert the shelf clips in the desired height (remember all
shelf clips will need to be installed at the same height to keep the
shelf level.)
Once the shelves are installed the remaining threaded holes will have
thumb screws inserted. These thumb screws are provided in the unit.
SETUP
SHELF INSTALLATION:
For Proper Shelf Clip Installation Please Read The Following
Instructions.
STEP 1
Install the top tab of the shelf clip into the proper hole. Push up on
the bottom of the clip. (See image 1).
STEP 2
Bottom tab of the shelf clip will fit tightly. You may need to squeeze or
twist the bottom of the shelf clip to install. (See image 2 & 3).
STEP 3
After installation, the shelf clip will fit snug into the shelf standard.
The shelf clip should not be loose or able to wiggle out of the shelf
standard.
SHELF INSTALLATION TIPS
1. Install all the shelf clips before installing the shelves.
2. Start at the bottom in terms of shelf installation and work your
way up.
3. Always lay the back of each shelf down on the rear clips before
the front.
WARNING!
Do not use pliers or any crimping tools
when installing shelf clips. Altering shelf clips
in any way can lead to shelving instability.
1
3
2
4
Type Kit #4 (Shelf Standards / Shelf Clips)
Shelf
Shelf
Standards
Shelf
Clip
Shelf
Loading ...
Loading ...
Loading ...