Loading ...
Loading ...
Loading ...
www.linarie.com.au
Positioning ELECTRICAL CONNECTIONS
7. INSTALLATION
6
The wiring of oven must be equipped with all-pole
disconnection device according to the wiring rules.
Important: The hob should never be installed in proximity
of a door access. People opening and closing the door
could come into contact with pots or pans cooking on
the hob. This unit may be installed and used only in
permanently ventilated rooms.
Unpacking
Installation
1. Be careful when unpacking and installing the appliance.
Sharp edges might cause accidents.
2. The oven is heavy and care must be taken when moving
it. Ensure that all packing, both inside and outside the
cooker, has been removed before the oven is used.
3. Unpack the oven from the carton, check and make sure
it has not been damaged in any way. If you have any
doubts, do not use it, contact the service center or
where you buy the oven.
The cooker is designed to fit between kitchen cabinets. The space either side need only be sufficient to allow withdrawal of
the cooker for servicing. It can be
used with cabinet one side or both as well as in a corner setting. It can also be used free-standing.
The appliances can be installed next to furniture units which are no taller than the top of the cooker hobs. If the cooker is
placed touching walls or sides of neighboring cabinets, these must be capable of withstanding a temperature rise of 50°C
above room temperature. For a correct installation of the cooker the following precautions must be followed:
1. The cooker may be located in a kitchen, a diner or bed sitting room, but not in a bathroom or shower room.
2. Kitchen cabinet installed next to the cooker that are taller than the top of the cooker hobs must be situated at least 20 cm
from the edge of the hobs.
3. Hoods must be installed according to the requirements in the installation manual for the hoods themselves and in any case
at a minimum distance of 65 cm.
4. Place the wall cabinets adjacent to the hood at a minimum height of 42 cm from the hobs as indicated in figure 1.
5. The hoods must be installed according to the requirements in the hood handbook.
6. Should the cooker be installed beneath a wall cabinet, the latter should be situated at least 70 cm away from the hobs as
indicated in figure 1.
7. cut-out for the cooker cabinet should have the dimensions indicated in the figure 1.
8. The wall in contact with the back of the cooker must be of flameproof material.
Important information
After installing the appliance, it is necessary to have other
methods to disconnect the power supply. The power
supply is disconnected by a contactable plug or by a fixed
wiring switch that meets the wiring requirements.
The following instructions should be read by a qualified techni-
cian to ensure that the appliance is installed, regulated and
technically serviced correctly in compliance with current regu-
lations. Important: remember to disconnect the appliance from
electricity by turn off the mains before regulating the appliance
or carrying out any maintenance work.
Min. 50cm
Cooker Hood
Min. 42cm Min. 42cm
Min. 70cm
without
hood
Min. 65cm
with hood
Loading ...
Loading ...
Loading ...