Loading ...
Loading ...
Loading ...
11
www.linarie.com.au
CAUTION!
If
The probe used in the oven is a mechanical physical
probe. Do not replace it without authorization.
In case of abnormal temperature sensing of the sensor
probe, please contact the designated repair shop
immediately for replacement.
the glass has some scratches, it may lead to crack.
Don't use the glass container corrosive cleaning product
or detergent to clean the glass.
Repla Sensor Probe Replacementcement of the oven light bulb.
cont. cleaning & maintenance
WARNING
Disconnect the appliance from the electrical supply.
Open the oven and remove the shelves.
The oven has a light with the following characteristics:
25W and 300°C.
Bulb and cover.
1. During use of the appliance, it becomes hot.
Care should be taken and avoid touching the
heating elements inside the oven.
2. Ensure that the appliance is switch off before replacing
the lamp to avoid the possibi
lity of electric shock.
3. Remove the glass cover that protects the light bulb by
turning it counter clockwise.
4. Unscrew the old light bulb and dispose it safely and
ecologically.
The glass cover may be tight, may need a stronger grip
to release it. Please release as shown.
Note:
Not covered by the appliance guarantee.
90°
Problem Possible Cause
Possible Solution
The oven is not
working
Interrupted electrical current Check other electrical appliances if it is working.
Breaker mulfunction Check your breaker if it is working fine.
Forgot the activate the timer
function
Reset the timer function
The lamp is not
turning on
Defective lamp
Replace with a new lamp.
No electrical current Check if the oven have electrical power.
Oven suddenly
stop working
Normal close thermostat
protection
Check if the cooling fan is working. If yes,
replace with new thermostat.
Power interrupted Check f
or other appliances if it is working.
Oven is not
heating during
operation
There is water
coming out from
the glass
when
operating.
Heating element is damaged.
Check and adjust the timer.
Door seal is worn out.
Weak or damage hinges.
Replace the door seal.
Replace the hinges.
12. TROUBLESHOOTING
Replace the heating element.
No power
Timer may have been set up.
Check and setup the temperature.
Can not adjust the temperature
controller.
Check the power box.
WARNING
Any electrical repairs to this appliance must conform to your local, state and federal laws. Please contact the service center if in any
doubt before undertaking any of the above. Always disconnect the unit from the power source when opening the unit.
If you have completed all of the above checks and is still experiencing difficulty,
please contact your local Linärie Service Center (see the “Warranty and Spare Parts” sections).
Obser
ve all safety and warning information during operation. ( see the General Safety Instructions” section)
Loading ...
Loading ...
Loading ...