Loading ...
Loading ...
Loading ...
EN
9
3 Installation
Transportation
Instructions
1. The appliance should be transported
only in a vertical upright position.
The packing as supplied must be
intact during transportation.
2. If during the course of transport
the appliance has to be transported
horizontally, it must only be laid on
its right hand side when standing
in the front of the appliance. After
bringing it to upright position,it must
not be operated for at least 4 hours
to allow the system to settle.
3. Failure to comply with the above
instructions could result in damage
occuring to the appliance. The
manufacturer will not be held
responsible if these instructions are
disregarded.
4. The appliance must be protected
against rain, moisture and other
atmospheric influences.
5. Empty any water in the drain
tray before moving see section
“Defrosting” and “Cleaning & Care”
for further information
Important :
Make sure the plastic evaporating
pan at the back of the product collects
water properly.
Important :
Care must be taken while cleaning
/ carrying the appliance to avoid
touching the bottom of the condenser
metal wires at the back of theappliance
as you might injure your fingers and
hands.
Important :
This appliance is not designed for
stacking with any other appliance.
When positioning your appliance,
take care not to damage your flooring,
pipes,wall coverings etc. Do not move
the appliance by pulling by the door or
handle.Do not attempt to sit or stand
on top of your appliance as it is not
designed for such use. You could injure
yourself or damage the appliance.
Important :
Make sure that mains cable is not
caught under the appliance during and
after carrying / moving the appliance,
to avoid the mains cable becoming cut
or damaged.”Do not allow children to
play with the appliance or tamper with
the controls.
Installation Instructions
1. If possible avoid placing the
appliance near cookers, radiators or
in direct sunlight as this will cause
the compressor to run for long
periods. If installed next to a source
of heat or refrigerator, maintain the
following minimum side clearances:
From Cookers 2” (50 mm)
From Radiators 12” (300 mm)
From Refrigerators or Larder Fridge
1” (25 mm)
2. No gap is required at sides and top.
See item 3 below to ensure a gap is
obtained at the rear of the appliance.
If a gap is available on side and
top, retain it if possible as it would
improve the air circulation around
the appliance.
3. Fit the two plastic wall spacer
supplied with the appliance on to
the condenser at the back of the
Loading ...
Loading ...
Loading ...