Loading ...
Loading ...
Loading ...
ASSEMBLY OF HOPPER BAG
STEP 11 = ASSEMBLE TUBES
Fit the ends of the two upper hopper tubes into the
ends of a rear hopper tube. Align the holes in the ends
of the tubes and secure them in place using two curved
head bolts (Q) and nylock nuts (R). See figure 8.
Fit the ends of the two lower hopper tubes into the
ends of a rear hopper tube. Align the holes in the ends
of the tubes and secure them in place using two curved
head bolts (Q) and nylock nuts (R). See figure 8.
Insert a clevis pin (O) from the outside into each lower
hopper tube and secure it with a hair cotter pin (M).
See figure 8.
NOTE: Either side of the rear hopper tube can face up.
STEP 12 -ASSEMBLE TUBES TO BAG
Unfold the hopper bag, reverse the fold of the mesh
wind screen and then lay the bag out flat with the wind
screen on top.
Insert the ends of the assembled upper hopper tubes
down through the stitched sleeves in the sides of the
hopper bag and then slide the tubes back underneath
the wind screen. See figure 9.
STITCHED SLEEVE
UPPER
HOPPER
TUBE
REAR
HOPPER
TUBE
NYLOCK
NUT (R)
CURVED HEAD
Bo_ (Q)
UPPER
HOPPER
TUBE
NYLOCK
REAR NUT (R)
HOPPER /
TUBE /rl ==
_"_ _ CLEVIS PIN (O)
LOWER -='='_"'_/ HAIR COTTER PmN(M)
HOPPER TUBE
FIGURE 8
FIGURE 9
HOPPER
BAG
BOTTOM
Place the assembled lower hopper tubes into the
bottom of the hopper bag and then slide the tubes to
the back of the bag. See figure 10.
Attach the ends of the lower hopper tubes to the
inside of the upper hopper tubes using two clevis pins
(N) inserted from the inside, and two hair cotter pins
(M). See figure 10.
UPPER HOPPER
LOWERHOPPER TUBE
HAIRCOTTER
PIN (a)
\
t
CLEVIS PiN (N)
HOPPER BAG
BOTTOM
FIGURE 10
Loading ...
Loading ...
Loading ...